Replacement lamp for SIDEL SBO Series 2

Fri, 05 Jun 2026 03:15:27 +0800

On the plant floor, an SBO Series 2 blow molder doesn’t wait for a lamp to “fail gracefully.” When the heating tunnel starts drifting, preforms come out uneven, and the line either throttles back or starts scrapping bottles. What you need is a drop-in replacement that restores the original thermal profile—without paying OEM prices. What matters technically Our replacement lamp for the SBO Series 2 is built to match the OEM infrared output, with the same wattage, voltage, and envelope dimensions. High-purity quartz tube, stable halogen/infrared filament design—built to deliver repeatable heat density across the heating zone. The R7s connector and end-seal geometry are 1:1 to the spec, so it seats and locks the same way on the reflector rail. In practice, that means you keep the same preform temperature spread, the same startup response, and the same run-to-run stability. Here’s why this matters: in stretch blow molding, the heating tunnel is the bottleneck you can’t paper over. Matching the lamp’s output curve and response keeps the preform in spec, which cuts pinholes, PET degradation, and weight creep. Plus, you lower operating cost. The emitter is engineered for long life—we’ve got units running 5,000+ hours with less than 5% output drop. Fewer changeovers, less downtime, and fewer spares tied up on the shelf. Installation and practical notes Installation is straightforward, but treat the lamp like the sensitive component it is. Always use clean gloves or a lint-free cloth when mounting—surface contact can create hot spots and shorten life. Confirm voltage and connector match on your exact SBO 2 configuration; some variants differ by zone and wattage. And match the lamp to the reflector condition. If the reflector is oxidized or out of alignment, even a perfect lamp will underperform.

Series on Warm IR Patio Lab Systems

Replacement lamp for SIDEL SBO Series 2